introduction > specification >coordinate system

Coordinate System

・Change the current coordinate system, Define by 3 points, Define by 2 lines, Move the point of origin, Move parallel, Initialize

.Only one coordinate system can be defined in each node.

・The coordinate system added to the top node is equivalent to a whole coordinate system.

The commands related to a coordinate system and coordinate axes, such as create demensions and create sections, are handled in the current coordinate system.

・The coordinate axes which show the posture of a current coordinate system are displayed.
・It also has the function which returns to the initial coordinate system which the node holds.
・2D port origin point is reffered the origin point of current coordinate system which is created the sections or views.